How to change the Hytel system time/date.
Attendant programming mode can be accessed from any display
telephone connected to the system that has not had the
function key disabled in system
programming. There are three large square
soft keys directly beneath the LCD dispaly. These
three keys relate to the
bottom line on the display. Pressing a particular soft key will invoke the
function written on the LCD
display that corresponds to that key's position
(left-right-center) such as "save"
"next" "dir" "name" etc)
Enter attendant programming mode by leaving the handset
on-hook, pressing the Function key and dialing # 0
"Tenant Group:_" is displayed on the LCD
Dial 1
(This assumes that the extension you
are dialing from belongs to tenant 1 in system programming (which is the case
for 99.9% of
the installed systems. If the extension belongs to another tenant, dial the appropriate
tenant digit).
Press soft key [F2]
below the word
"save".
"PSWD:_" is displayed on the LCD
Dial 0000 (This is the default password for
the nominated system attendant’s extension (normally extension 201). If the default
password has been changed, dial the password for the attendant’s extension instead of
four zeros)
Press soft key [F2] below the word
"show".
"SYSTEM ABBR. NO." is displayed on the LCD
Press soft key [F2] below the word "next" until "SYSTEM TIME" is displayed on the LCD
Press soft key [F3] below the word
"show".
"YEAR:" is displayed on the LCD
Press soft key [F2] below the word
"next" to
cycle through the following parameters:
YEAR / MONTH / DAY / WEEKDAY / HOUR / MINUTE
Press soft key [F3] below the word "chg" to edit a parameter
Enter digits to edit a parameter. Enter 2
digits for the year (eg. 01 for year 2001). Note that the "hour" must be entered
using
24-hour format (i.e. 3.00 p.m. is entered as "15").
Press soft key [F2] below the word "save" to save the changes
Press soft key [F2]
below the word
"next" to step through the parameters
YEAR / MONTH / DAY / WEEKDAY / HOUR / MINUTE again and edit other settings.
Press the Clear key to exit programming mode when finished.